General Disclaimer: (HV) (DC) injury or death hazard, use at your own risk, may void warranty. |
User contributions
Jump to navigation
Jump to search
- 20:14, 1 January 2007 diff hist +3,784 PriusPlus-Theory →The PHEV Battery Pack
- 04:32, 24 December 2006 diff hist -98 PriusPlus-Electrical Oops, put stuff in the wrong sections
- 04:30, 24 December 2006 diff hist +1 m PriusPlus-Electrical Minor mistake
- 04:30, 24 December 2006 diff hist +2,385 PriusPlus-Electrical Added more categories and tips for safe battery handling
- 03:35, 24 December 2006 diff hist +796 PriusPlus-Mechanical Started battery box base documentation
- 03:21, 24 December 2006 diff hist +1 m PriusPlus-Mechanical Minor mistake
- 03:20, 24 December 2006 diff hist +1 m PriusPlus-Mechanical →Parts Needed
- 03:20, 24 December 2006 diff hist +4,868 PriusPlus-Mechanical Added battery box top instructions and photos
- 02:41, 24 December 2006 diff hist +695 PriusPlus-Mechanical cleaned up and added measurements to battery tray instructions
- 18:02, 22 December 2006 diff hist +1,006 PriusPlus-Mechanical Started Battery Box Top Documentation
- 17:46, 22 December 2006 diff hist +414 PriusPlus-Mechanical →Battery Trays
- 20:37, 18 December 2006 diff hist +836 PriusPlus-RawData Added more photos to Chris Ewert's conversion
- 23:02, 17 December 2006 diff hist +247 N File:Mostly Finished Batt Box.JPG Mostly finished battery box. Holes still need to be drilled into the angle irons to bolt down, and bolts will be added in the middle between the trays to bolt the top of the pack to the bottom. Also, mounting frame is not completely cut to size. current
- 22:57, 17 December 2006 diff hist +100 N File:Finished Corner.JPG Finished corner with ground of screws. I'm pretty sure this isn't done the official CalCars method. current
- 22:56, 17 December 2006 diff hist +180 N File:Binding Posts Ground Down.JPG These are the binding posts I choose to use. The one on the left is ground down to fit and the burs are also ground off. I'm sure there is a better way to do this, but it worked. current
- 22:54, 17 December 2006 diff hist +93 N File:Inside Corner.JPG Inside the corner bracket. The machine screws are counter sunk into the aluminum angle iron. current
- 22:53, 17 December 2006 diff hist +128 N File:Batt Box with Bolt Down Angle.JPG Corner bracket in place and screwed down on the top. Ready to drill holes in the side and bolt down the bracket from the sides. current
- 22:51, 17 December 2006 diff hist +264 N File:Plexiglass Shield.JPG I choose to install a plexiglass 'shield' on the side of the aluminum angle iron to reduce the risk of a wire / terminal hitting the aluminum and arcing. I am not sure if that is in the official CalCars plans or not. It is held in by non-conductive nylo current
- 22:43, 17 December 2006 diff hist +81 N File:Batt Box Top 3 Angles.JPG Aluminum angle irons cut with 45 degree angles and laid on top of the battery box current
- 15:40, 15 December 2006 diff hist +1,539 PriusPlus-RawData Added Chris's Battery Box Photos