General Disclaimer: (HV) (DC) injury or death hazard, use at your own risk, may void warranty. |
Difference between revisions of "Talk:PriusPlus-Mechanical"
Jump to navigation
Jump to search
(todos) |
(updated todo) |
||
Line 3: | Line 3: | ||
Todo (high priority): | Todo (high priority): | ||
Someone who has done a "classic" PriusPlus conversion needs to do the following: | Someone who has done a "classic" PriusPlus conversion needs to do the following: | ||
− | |||
− | |||
− | |||
− | |||
− | |||
+ | # Verify battery box base mounting / touch up / add any details needed (classic PriusPlus method) | ||
+ | # Write up mounting the GFCI outlet box in the tire well (classic PriusPlus method) | ||
+ | # Write up mounting the DeltaQ charger in the driver's side cubby hole | ||
+ | # Write up cutting and assembly of electronics tray plastic (classic PriusPlus method.) | ||
+ | # Write up mounting the electronics tray components (diagrams are created and on the page already, wiring is a different section, | ||
# Write up battery box base mounting for alt. mounting method (Chris) | # Write up battery box base mounting for alt. mounting method (Chris) |
Latest revision as of 16:06, 16 June 2007
This is here for the time being to help with organizing:
Todo (high priority): Someone who has done a "classic" PriusPlus conversion needs to do the following:
- Verify battery box base mounting / touch up / add any details needed (classic PriusPlus method)
- Write up mounting the GFCI outlet box in the tire well (classic PriusPlus method)
- Write up mounting the DeltaQ charger in the driver's side cubby hole
- Write up cutting and assembly of electronics tray plastic (classic PriusPlus method.)
- Write up mounting the electronics tray components (diagrams are created and on the page already, wiring is a different section,
- Write up battery box base mounting for alt. mounting method (Chris)
- Write up mounting the charger alt. mounting method (Chris)
- Write up assembly of electronics box plastic for alt. mounting method (Chris)
Todo (low priority):
- Write up Prius re-assembly instructions.
- Write up mounting the cord reel
- Write up installing the bumper inlet (options for front or rear + routing cables)
- Write up Amp meter mounting (to be listed as optional)
- Write up diagnostic LEDs board mounting - Use self-tapping screws to mount it to the roof of the tray just inside the glass door under the radio. To run the ribbon cable, open up the dash and run a cable as shown it this diagram [or drill a hole in the back of the tray, at the upper left as you look at it]. (Make and add diagram.)
- V4 Screen mounting (low priority because it can be found elsewhere)