General Disclaimer: (HV) (DC) injury or death hazard, use at your own risk, may void warranty. |
Difference between revisions of "Maker Faire Photos"
Jump to navigation
Jump to search
(more photos) |
(more photos) |
||
Line 20: | Line 20: | ||
Image:100 1162.JPG|The Seats are on the roof | Image:100 1162.JPG|The Seats are on the roof | ||
Image:100 1163.JPG|More interior parts on the roof | Image:100 1163.JPG|More interior parts on the roof | ||
+ | Image:100 1167.JPG|Makers Faire Crew doing their thing | ||
+ | Image:100 1168.JPG|OEM high power components 1/2 ''(Battery edge, Battery ECU, Tap Connector, Main Contactors, Precharge Resistor)'' | ||
+ | Image:100 1169.JPG|OEM high power components 2/2 ''(Battery edge, Battery ECU, Tap Connector, Main Contactors, Precharge Resistor)'' | ||
+ | Image:100 1170.JPG|HV disconnected to Inverter under hood. | ||
+ | Image:100 1171.JPG|Three connectors on the drivers rear side of the OEM HV box. | ||
+ | Image:100 1172.JPG|Disconnected control ground of one OEM main contactor to control Charge Interlock. | ||
+ | Image:100 1174.JPG|Tapped positive(+12v) control of one OEM main contactor for Ready ''(car on)'' Interlock. | ||
+ | Image:100 1176.JPG|''Lower Left to upper right'' Neg(-) Contactor, double small wires run through Hall Sensor where it rejoins OEM (-) battery cable and new PHEV (-) battery cable. ''above'' Pos(+) Contactor, new PHEV (+) cable to Inverters. ''left'' Pos(+) OEM battery cable, extended out for switching from OEM to PHEV battery. | ||
+ | Image:100 1182.JPG|Rewired Complete, HV (-), (+)Bat, (+)Inv, ribbon tap cable, (+)12v Ready Interlock, (-)Charge Interlock. | ||
+ | Image:100 1183.JPG|''grey'' OEM NiMH pack, and one of about 20 PbA PHEV batteries and half the rack. | ||
+ | Image:100 1187.JPG|''grey'' [[CAN-View]], ''black'' Video converter, HV and interiour nuts and bolts | ||
+ | Image:100 1188.JPG|Misc low power cables under rear passenger door molding. | ||
+ | Image:100 1189.JPG|Misc low power cables over rear passenger wheel well. | ||
</gallery> | </gallery> |
Revision as of 06:02, 5 May 2006
These are photos from the Inaugural Maker Faire See also:
- Jerry Pohorsky - Photoshow 1
- Jerry Pohorsky - Photoshow 2
- Jerry Pohorsky - Photoshow 3
- CNet News - video interview with Felix
- Inaugural Maker Faire#Post_EVent
CAN-View (grey) and video signal adapter (black) under passanger seat.
Battery Tap/Interconnect strip, with additional length of ribbon cable spliced in. See State Of Charge Manipulation & Battery Tap Emulator.
Delta-Q battery charger.
One of Four sub-pack modules made up of 5 12v 20Ah SLA PbA B&B Batteries.
grey CAN-View, black Video converter, HV and interiour nuts and bolts