General Disclaimer: (HV) (DC) injury or death hazard, use at your own risk, may void warranty. |
Difference between revisions of "Talk:PriusPlus-Mechanical"
Jump to navigation
Jump to search
(more todos) |
(todos) |
||
Line 2: | Line 2: | ||
Todo (high priority): | Todo (high priority): | ||
− | # | + | Someone who has done a "classic" PriusPlus conversion needs to do the following: |
− | # Write up mounting the GFCI outlet box | + | # Verify battery box base mounting |
+ | # Write up mounting the GFCI outlet box | ||
# Write up mounting the charger | # Write up mounting the charger | ||
# Write up assembly of electronics tray plastic | # Write up assembly of electronics tray plastic | ||
# Write up the mounting of the electronics tray | # Write up the mounting of the electronics tray | ||
− | + | ||
# Write up battery box base mounting for alt. mounting method (Chris) | # Write up battery box base mounting for alt. mounting method (Chris) | ||
Line 15: | Line 16: | ||
Todo (low priority): | Todo (low priority): | ||
+ | # Write up Prius re-assembly instructions. | ||
# Write up mounting the cord reel | # Write up mounting the cord reel | ||
# Write up installing the bumper inlet (options for front or rear + routing cables) | # Write up installing the bumper inlet (options for front or rear + routing cables) |
Revision as of 03:21, 4 June 2007
This is here for the time being to help with organizing:
Todo (high priority): Someone who has done a "classic" PriusPlus conversion needs to do the following:
- Verify battery box base mounting
- Write up mounting the GFCI outlet box
- Write up mounting the charger
- Write up assembly of electronics tray plastic
- Write up the mounting of the electronics tray
- Write up battery box base mounting for alt. mounting method (Chris)
- Write up mounting the charger alt. mounting method (Chris)
- Write up assembly of electronics box plastic for alt. mounting method (Chris)
Todo (low priority):
- Write up Prius re-assembly instructions.
- Write up mounting the cord reel
- Write up installing the bumper inlet (options for front or rear + routing cables)
- Write up Amp meter mounting (to be listed as optional)
- Write up diagnostic LEDs board mounting - Use self-tapping screws to mount it to the roof of the tray just inside the glass door under the radio. To run the ribbon cable, open up the dash and run a cable as shown it this diagram [or drill a hole in the back of the tray, at the upper left as you look at it]. (Make and add diagram.)
- V4 Screen mounting (low priority because it can be found elsewhere)